Wonder what possibilities Zortrax brings to toy industry? See an example of Mr. Walthersnap and friends by Jose Alves da Silva 3D printed on Zortrax M200 and prepared by David da Costa.

5123334d84a80312a98e3a1bae563d7b688867a9

Parts of the characters were designed by Jose Alves da Silva to be successfully 3D printed without the support. David printed all the models at 2 times the original model size using Z-ABS throughout. All prints were done at 0.14 layer thickness with a few exceptions like e. g. the heads which required higher resolution to make finishing easier.

Once printed, David proceeded the models as follows:

All parts were sanded with 320 grit sandpaper (in some cases he used 200 first for rough areas). Then compressed air to remove all dust.

d67e1439cdb09c85b4e63da510db56c1af505c9f

He sprayed a thin coat of Deft lacquer sanding sealer which is to help fill in the “troughs” between each layer and smooth the surface. After the model dried completely, he sanded the piece again.

a00a4780e857d92bcb5fe7dcbca5f94896073036

Next, he sprayed a coat of Rustoleum 2 in 1 filler & sandable primer. This starts to fill in the troughs between layers and also makes it easier to see which areas require further sanding or filling.

676758e81b37bdcf6b5fdb74df42ad30376b6c22

He left the piece to dry, then he sanded it again with 320 grit sandpaper. Next, he used Tamiya putty to fill any remaining rough areas or any occasional small areas of delamination, which happens sometimes with large, long duration prints.

Once he finished, he drilled a small hole in one of the joint surfaces of the model that will not be seen and hot glued a wooden skewer into the hole to provide a place to hold the model while painting. Then sprayed a coat of Tamiya fine gray primer and did a final check of the model and moved on applying the final paint.

4fb340be7d9dcbab808f32464e50cc1ba38b03f5

David used mainly acrylic paints such as Golden Fluid and high flow acrylics, Tamiya, Valejo and Garage kits. For special finishes such as the chrome and metallic areas on the engines and wings of Eddie the dog, he used Alclad II lacquers and enamels.

An airbrush for most of the base, shadow and highlights colors used if needed, for details like eyes and any washes – a brush.

Once all the color have been applied he finished with Testers dull coat in most areas with the exception of metallic or chromed areas which he sprayed a thin coat of Pledge Future and the eyes which he finished with a coat of gloss acrylic varnish.

Once all the paint is complete and dry, he assembled the model. On these particular models he used mostly hot glue (hot glue gun) to assembles. For some of the smaller of tight fitting parts he used crazy glue.

The final effect is brilliant!

Visit David’s website

2 comments

  • Adela Fitzgerald posted Jul 20, 2016 - 10:39

    Hey there, I think your website might be having browser compatibility issues. When I look at your blog in Firefox, it looks fine but when opening in Internet Explorer, it has some overlapping. I just wanted to give you a quick heads up! Other then that, very good blog!

    Reply
    • Ludmiła Rafalska posted Jul 21, 2016 - 15:21

      Hey @Adela, thanks for letting us know, we will try to do something about this. It’s really nice to hear that you find the contents on our blog interesting.

      Reply